Cisco认证实验考试经典题库CCIE_BootCamp3.0(第七章)[1]

【网络综合 - Cisco认证试题】
d. routers r1, r3 and r5 should share network 10.10.x.x 255.255.0.0 on their frame-relay interfaces.
e. routers r1 and r2 should share network 10.20.x.x 255.255.0.0 on their frame-relay interfaces.
f. router r1 should have network 10.1.x.x with a 9-bit subnet mask on its ethernet interface.(the mask should be 255.255.128.0) sue subnet-zero here.
g. router r2 should have network 137.20.20.0 with a 24-bit mask on its ethernet interface.
h. router r3 should have network 10.3.x.x with an 8-bit subnet mask on its token-ring interface. (the mask should be 255.255.0.0)
i. use network 11.1.x.x 255.255.0.0 between routers r5 &r6.

2. ospf & other ip routing configuration –35 pts (1hous 30 mins)
a. configure ospf area 0 on the frame-relay interfaces between routers r1,r3, and r5.
b. place router r1’s ethernet in ospf area 1. place router r3’s interface to 0 in ospf area 2.
c. place router r3’s interface serial 0, and all of router r4 in ospf area 3. make ospf area 3 a totally-stubby area.
d. place r5 and r6 ethernet interface in ospf area 4. make this ospf area a nssa (not-so-stubby-area) make the default cost 20.
e. configure router r6’s interface serial 0 and router r8’s interfaces s0, e0,and loop 0 for eigrp.
f. place router r2’s interface serial 0 and router r1’s s0.1 in ospf area 5.
g. redistribute all routes so that you can see all routes and ping from everywhere.
h. summarize the routers for router r8’s interface e0, loop0, and s0 that were redistributed into ospf by router r6 on router r5 so that all of router r8’s networks appear as one route to the rest of the ospf routers except r6.
i. when you redistribute eigrp into ospf make these routes appear as type-1 external routes.
j. configure router r2 such that it propagates a default route the other ospf routers.
k. create a second loCisco认证